The effect of mixing in the modelling of processes based on mass transfer phenomena is commonly ignored in wastewater treatment industry. In this contribution, the effect of the average shear rate in the nucleation and growth rates of struvite is analyzed by combining experimental data with simulation results obtained with a previously presented mass-based discretized population balance model. According to the obtained results, the effect of the average shear rate is identifiable for the selected data and mechanisms. Therefore, it should be considered when a detailed modelling of the process is needed. Consequently, in this contribution, the average shear rate has been decoupled from the kinetic constants. In addition, kinetic rates where it is explicitly included as a power law function have been proposed. The exponents in these power law functions for the primary homogeneous nucleation and growth are 1.3 and 0.3, respectively. Considering shear rate effects allowed to see in the simulation outputs experimentally observed effects: a faster pH decay and smaller particle distribution for increasing mixing intensities. (c) 2021 Elsevier Ltd. All rights reserved.

Controlled struvite precipitation is a promising solution for phosphorus recovery in wastewater treatment plants. Particle size distribution of recovered struvite affects its efficacy as a fertilizer, so should be considered in the design and operation of struvite recovery reactors. This contribution analyzes the effect of varying the average shear rate (between 150 s(-1) and 876 s(-1)) and saturation index (between 0.76 and 2.96) in two different experimental set-ups. Solution pH and particle number and size measurements using an electric zone sensing method are used to monitor the process. In addition, photomicrographs are used to observe the shape of the precipitated particles. Interestingly, for identical thermochemical conditions, a higher mixing intensity, associated with the shear rate, leads to shorter induction times, faster precipitation and a greater particle density. On the other hand, for similar mixing conditions, a higher saturation index is also linked with shorter induction times, faster precipitation and a greater particle density. From the experimental data it is concluded that the effect of the fluid shear rate cannot be ignored and should be further studied in the precipitation process.

Struvite precipitation has raised as a promising solution to recover phosphorous in wastewater treatment plants (WWTP). Struvite is a fertilizer that varies its performance depending on its size. This shows the need to upgrade one-step classic kinetic precipitation models by new frameworks as the Population Balance Model (PBM). In this abstract a mass-based Discretized Population Balance Model (DPBM) used to predict struvite precipitation is presented. The model includes primary nucleation, growth and aggregation mechanisms as a function of supersaturation index and kinetic parameters. Main advantage of the mass-based definition is that mass continuity is guaranteed and that it is fully compatible with other chemical and physicochemical reactions. A sensitivity analysis performed reveals exponents of nucleation and growth as the most relevant parameters in the pH evolution during precipitation and final Particle Size Distribution (PSD). Experimental data was used to calibrate the model employing Bayesian Inference. Selected values of the parameters showed good agreement with reality.